Once the top of the lockers is attached, secure the backboard to the lockers using the 6’ of 1/4” Plywood panels. Secure it to the dividers using wood glue and the pocket hole screws. Again, make sure the pocket holes are facing the back of the lockersĪttach the top of the lockers using the 8’ x 18” 1/2” Plywood. DIYCurtains & RodsVenetian Blinds and Roller BlindsAdhesive Film & WallpaperDecor & Furniture PaintFloor & Wall TilesHandlesWall & Floating ShelvesHooks. Next, add the spacer boards directly below the shelves. Make sure the pocket holes are facing the back of the lockers to ensure they are not visible once fully assembled. I start with the bottom spacers and secure them to the divider boards with wood glue and the pocket hole screws. Use a square to ensure that the shelves are all square before securing them to the divider boards with the Kreg pocket hole screws.Īdd the spacers to the lockers using the 16 23” 1 x 4 x 8 standard pine boards. Behind every door is storage for coats, boots, a backpack, hats and other odds and ends. I make sure to align the top of the shelve to the bottom of my scribe line and keep that consistent with each shelf I add. 101250 Introduction Neaten up your mudroom with these simple, hide-the-mess lockers. I apply wood glue to either the divider board or the shelve and align it to the mark I made. The Tools for School locker shelf allows you to increase storage space in a locker and will help to keep you organized. This is where each shelve will be aligned and secured to the dividers. Mark 18” down from the top of each divider and scribe a line on each divider board. To assemble the top lockers, first stand each divider horizontally. Repeat this process to build the second 8’ bench. Do not line them up to the edge of the board as we have already accounted for the thickness of the board in our initial calculations. Keep in mind that when placing these divider boards on these lines you will need to center the divider board on these marks. This entire mudroom system cost about 600 for 14 feet long Heres the template for the base. These lines are the center marks for where the remaining divider boards need to be placed. From that mark measure out 23’ two more times. Once the first divider board is secured to the base I can measure from the edge of that divider 23’ and make a mark. I take that number and divide it by the total number of cubbies I will have. To evenly space the boards, take the total length of the base (96’) minus the thickness of each divider board (.75’ x 5 = 3.75’) This comes out to 92 1/4". Use a square to ensure that the divider is at a 90 degree angle to the base and secure with pocket screws. Apply a thin line of wood glue to the edge of the base and align the first divider board flush with the edge of the base. To attach the dividers to the base lay the base flat on the ground.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |